-
Recent Posts
Recent Comments
- scsvcs on Sports Car Services Website News
- Tom Rymes on Sports Car Services Website News
- David Clark on Sports Car Services Website News
- Eric Duram on Sports Car Services Website News
- David Clark on Repairs Complete
Archives
- March 2015
- February 2015
- January 2015
- December 2014
- November 2014
- October 2014
- September 2014
- August 2014
- July 2014
- June 2014
- May 2014
- April 2014
- March 2014
- February 2014
- January 2014
- December 2013
- November 2013
- October 2013
- September 2013
- August 2013
- July 2013
- June 2013
- May 2013
- April 2013
- March 2013
- February 2013
- January 2013
- December 2012
- November 2012
- October 2012
- September 2012
- August 2012
- July 2012
- June 2012
- May 2012
- April 2012
- March 2012
- February 2012
- January 2012
- December 2011
- November 2011
- October 2011
- September 2011
- August 2011
- July 2011
- June 2011
- May 2011
- April 2011
- March 2011
- February 2011
- January 2011
Categories
Meta
Pages
Monthly Archives: January 2013
A Cold and Busy Week
An Alberta Clipper is making its presence known here. The outdoor thermometer needle is bouncing off zero (it’s 48 degrees here in my office right now) with a fierce wind that is propelling the wind chill well into the minus … Continue reading
Posted in This week at the shop
Comments Off on A Cold and Busy Week
Some Snow But A Roadtest, Too
It snowed most of the day Wednesday which wasn’t really a disruption for us because no roadtesting was on our schedule. On the left you can see what it looked like around 7:00 in the morning from my faithful rubber … Continue reading
Posted in This week at the shop
Comments Off on Some Snow But A Roadtest, Too
Mostly, But Not All MG’s
The new owner knocked down this very attractive MG TD over the summer at the Owls Head Museum Auction. He drove it a little and then asked us last fall to sort a few things out, which we’re starting to … Continue reading
Posted in This week at the shop
Comments Off on Mostly, But Not All MG’s
A Tale of Two Gasket Sets
When I’m putting an engine together I always snap a picture of the completed timing gear assembly so that I know tab washers have been bent, the tensioner slipper has been released against the chain and that the crankshaft oil … Continue reading
Posted in This week at the shop
Comments Off on A Tale of Two Gasket Sets